Stay Signed In
Do you want to access your site more quickly on this computer? Check this box, and your username and password will be remembered for two weeks. Click logout to turn this off.
Stay Safe
Do not check this box if you are using a public computer. You don't want anyone seeing your personal info or messing with your site.
Only approved Reliant bodyshells are permitted. Approval of any other bodyshell not listed below can only be used with the approval of Alec Quarman before using, his decision is final!
These are the approved shells: Reliant Regal and Reliant Robin.
Chassis material to be of GRP material or similar. The chassis must not protrude beyond the bodyshell.
The roof fin must be fitted to the roof of the car and must not have sharp edges, and must be plastic. They must have the driver's number clearly visible.
Driver's name & number must be visible on both sides of the car.
Roof grades will be updated every 2 months. Please telephone if unsure of your grade. All cars must display correct roof grade, minimum 2" wide stripe. Anyone displaying incorrect roof grade will start from the back of the grid.
Bumpers are not permitted. In the interest of servo protection, aluminimum bumper plates with foam fitted are allowed.
Foam Tyres only!!
You may use glue sticks, tape, cable ties, plastic joining plates or plastic door plate in conjunction with nuts & bolts as to their full size counterparts. The above repair methods are allowed anywhere on the inside of the bodyshell only. Neither armouring allowed nor the use of mastic.
No mascots or bolt on engines or dummys etc. on the outside of the car.
Windows must be completely removed as close to original car as possible.
The external painting of the car must be neatly finished, with no unsightly, rude or offensive slogans or gestures.
You may use 2,3 or 4 body mounts, no more or less. These may be of any material, not exceeding 10mm in width and must not protrude more than 10mm through the bodyshell.
Mardave mechanical & resistor type speed controllers only. No Electronic Speedos!
Any type of servo saver allowed.
Original mardave axle with moulded spur gear/wheel or V12/R12 axles with 46T, 48T or 50T spur gears are permiteed.
Ball races may only be used on the back axle.
Motors must be the Mardave G1 & G2, and the Grapner 500 standard, Johnson 540 with plastic endbell, HPI Saturn 27T,
Tamiya Mabuchi 540 Silver Can with black endbell. All motors must be 27 Turns and have all identification labels intact,
all tabs must remain untouched. (These Identification stickers do not come off). Heat sinks can be fitted.
Use of motor cleaning fluids & additives allowed. Hunter Systems 27T motor TBC.
Batteries can only be 4 cell Sub C nicads & nimh cells permitted, max 4600 Mah, and must be covered in clear heat shrink or the manufacturers covering with identification clearly visible.
Transponders must be chassis mounted only via non-metallic bracket, no exceptions !
